If none of that works, do this: Take a paper towel and thoroughly wipe out the inside of the distributor cap making sure to get all particles of trash out of it, and off of contacts. Then, after that, take a can of WD40 and spray a THIN film inside the distributor cap. (DO NOT overdo this. You should have NO excessive "run" whatsoever) Don't wipe out the film of WD40. Leave it in there. Replace distributor cap and try to start. I had to do this on my 1990 Civic LX after my dad "washed"...

amsjsj wrote: Valves that you can hear are much better than valves you can't hear. :-( 'Curly' =================

BOB wrote: Bob, If your return address is "facil.honda.org", does that mean you work in a French-Canadian Honda dealership that has no service manuals? My French is not very good. Try a google.ca search (available in French too) for the words 'honda

I had 99 Accord with the same problem right from day one. My wife noticed moisture in the lense as they were washing it just before we drove it away. This was a brand new car. The dealer replaced the headlight housing (lense) 4 times under warranty. Finally the bulb blew, I guess from all the moisture, after it was replaced we never had the problem again. Bad seal on the bulb! I have to add, that bulb was the only expense other than regular maintenance with the car. I leased for four years put...

For the D16Z6 engine the torque for the bolts holding the rocker arm assembly is 20 Nm or 14 lb ft. The service manual specifies the sequence in which to tighten the bolts. I'll send you a scan of the service manual to the "from" address from you post. If it is a decoy e-mail address, post your real one and I'll send the scan there. John wrote:

I have figured out that the bulbs are soldered, and more importantly the bulb for the LCD panel is soldered within the plastic housing for the the display (which is again soldered about 15-20 times to the back board). Looks like I just need to find a complete LCD module, which does, however, conveniently plug into the rest of the headset unit... Any ideas on where to pick one up used? Thanks again.

"Hammy" <null@null.net> wrote in message news:<MgFVb.17250$jH6.16729@newsread1.news.atl.earthlink.net>... http://www.insightcentral.net/ for more information, and also check out the forums there. more owners hang out here, and look through the archives for more information here: http://autos.groups.yahoo.com/group/honda-insight/ http://autos.groups.yahoo.com/group/honda-hybrid/ http://autos.groups.yahoo.com/group/civic_hybrid/

On Thu, 15 Jan 2004 09:04:44 -0600, TL <tlehman@visi.com> wrote:

Jonathan Upright wrote: If I remember correctly, the recall was only for the latching mechanism. It seems that the red plastic insert on one of the brands of latches that was used would crack and break apart. This would leave small bits of plastic down in the latch which would prevent it from functioning correctly. For example, I believe that there was mention of the seat belt potentially not restraining the driver/passenger in the event of a collision. Honda issued a service bulletin for...

You have four headlights, two hi and two low, no dual filiment bulbs, correct? Forget grounding problems, you have five seperate grounds and only the low beams are grounded near the lights, I looked at a 1990 Accord wiring diagram. Here in the city, I never use high beams and if you never use a bulb it should not burn out. Look at the light assemblies, are there any cracks or bad gasketing so cold water can get on the bulbs. When you installed the bulbs, did you

Robert, I don't have the answer to your question. But since you did it already, how do you obtain the ECU trouble code? what two wires do you bridge? (I have a '92 Accord LX) -- pjs7 ------------------------------------------------------------------------ Posted via RealCarAudio.com - The checkmate of the caraudio community. http://www.RealCarAudio.com

In article <__AVb.12861$Ig5.5526@fe2.texas.rr.com>, "agent smith" <agentsmith@UNDIES.the-c0re.tk> wrote: My advice is to buy an engine made for a daewoo since the engine mounts and various wiring harnesses,etc will match up perfectly and would require very little work on your part. That would not be the case if you tried to install an Accord/Prelude into it. I once talked to a person that placed a chevy engine in a ford. He told me that it was a the craziest idea he ever had. He spent over a...

If I am not mistaken, the only way you can get anti-lock brakes on a Honda is to buy the EX trim, if ant-lock brakes matter to you. "Ernest Cassirer" <erncass@foxinternet.net> wrote in message news:K9wVb.684$ss.22028@bcandid.telisphere.com...

Thanks for all the input. After checking a few places for the repair, I found them to be pretty close in price. Got it done for $215. I live in S. Florida, so road salt wasn't a factor. So the pipes and muffler lasted six years since the car was new, so I can't complain.

jim wrote: It's called merchandising. There are lots of products sold today that are just clones of a cheaper one done up with advertising and pizzaz and folks pay large for the stuff. Amway is one that comes to mind. Coke and Pepsi is just fizzy water and advertising. You could make as refreshing a drink in your home for pennies. Come to think of it why the hell why is is bottled water selling for as

Thanks very much to all who replied! Much appreciated information!-Satellite "satellite" <trispeed@airmail.net> wrote in message news:c05qmp$od5@library1.airnews.net...

Mine does. "George M" <laereht@hotmail.com> wrote in message news:Xns948865C7DBDE4laerehthotmailcom@24.168.128.74...

Another thing to note.... if an engine is needed you can pick up a used one for around $100 bucks plus shipping. www.car-part.com "chuck smoko" <csmoko@earthlink.net> wrote in message news:4026DBCE.C34D895D@earthlink.net...

I bought my 98 civic with almost 200 000 km in it, and got a discount for that (almost 5k canadian total price). I think if you can bring down the price (maybe by 500), it will be a good deal... you probably know better than me that if well taken care of, Hondas go well beyond 300 000 km. "'Curly Q. Links'" <motsco__@interbaun.com> wrote in message news:402560C8.CE47A736@interbaun.com...

Artfulcodger wrote: did and you posted to my reply... they may never get the message you have posted to.....